Can you use architectural shingles for ridge

If this had been my house, I absolutely would have used the store-bought hip and ridge shingles for the best look and result. So, if your strongest winds come from the north, and the ridge generally runs north — south, nail at the north side and lay the tar strip on the shingle on the south side. But, if your strongest winds come from the north and the ridge generally runs west east, I would just make a judgement call about whether or not the winds are stronger from the east or west and lay the ridge cap shingles based on that.

This video shows exactly how to cut the last shingle, use roofing cement, nail the last shingle on the ridge cap, then hide those nails. You can see me do that in the video below. Looking for more home maintenance projects?? Check out this easy DIY for making that ugly grout look new again.

How far should shingles overhang drip edge? The edge of the shingles should hang over a roof between an inch and an inch and a half — or between a half inch and three-quarters of an inch if drip edge flashing is installed. Too much overhang and the shingles could blow off in high winds; too little can allow water to seep into rake or fascia boards.

Do you overlap starter shingles? With the starter shingles laid along the very edge of the roof, run a set of starter shingles along the sides of the roof as well, making sure that those rows come down and overlap the starter shingles you laid at the bottom.

How do you stagger architectural shingles? The trick to laying asphalt shingles is to stagger the seams between courses. Begin shingle application at the lower left rake of roof. Continue the first course across roof with full shingles laid flush with the starter strip and fastened with four nails, placed as specified. Where do you nail shingles? What is filmstrip projector? You will not have to worry about your ridge caps not fitting in with the color scheme of your roof since contractors generally tailor these caps to fit well with your roof.

There are also some contractors who manually install ridge caps shingle by shingle for added authenticity. Overall, architectural shingles would work well as ridge caps since they are extremely resistant to almost every element of weather and can blend well with the other shingles of your roof.

Ridge caps are one of the most important parts of the roof since it is one of the first parts of the roof that people will see.

It is always important to ask yourself the following questions right before making any rational decisions:. Homeowners are advised to seek the help of professional roofing contractors who can provide skilled roofers to give extensive inspections to your roofing Fort Myers FL. You must be logged in to post a comment. Architectural Shingles During the s, dimensional shingles were getting a logical development in the form of architectural shingles.

Architectural shingles are usually comprised of the following materials: Heavy fiberglass mat base Ceramic-coated mineral granules Highly refined water-resistant asphalt Essentially, architectural shingles emulate the same texture and appearance of two widely-popular shingles like cedar shakes and slate tiles without the drawbacks and disadvantages of the two materials.

Thanks for any input. The Certainteed Master Shingle Applicator says to use accessory shingles for those or cut caps from shingles with tab cutouts 3-tab - not laminated shingles - the manual points out that the accessory shingles are far easier to use than cutting up tabbed shingles, which requires a total of 8 cuts per shingle to yield only 3 caps. There are supposed to be 24 scored accessory shingles in each bundle that will produce a total of 72 cap accessory shingles.

They're easier to use because they're marked for alignment and positioning so it's hard to get them off-center or use too little or too much headlap. You say they were cut on site; the accessory shingles come as a full shingle that's scored into thirds with the bottom edges notched so that when the three sections are separated from one another the corners are already nipped off and the tabs don't need to be trimmed.

If he cut those from laminated shingles, tell him he should go to the proctologist and get his eyes, ears and nose checked. And here are the instructions for Landmark Premium Series - Look specifically at pages and thru Thanks, Mike.

This helps so much. I know they were cutting 3 tab shingles this morning for this purpose but can't tell what they used yesterday. One side of the house looks ok and the other side has shingle edges that appear ragged across the ridges and hips.

I don't know if it was because there were different installers or if some used architectural and some used 3 tab shingles. If they did use 3 tab shingles all over and we'll have to determine this will they tend to smooth out as they are heated from the sun and become more pliable? Or should we insist that the supervisor who will be inspecting the project have the 3 tab shingles replaced with the accessory shingles if they were installed incorrectly?

If they are replaced, will all the nail holes from the shingles there now need to be filled in? I know about toe boards and insisted that they not be used except as absolutely necessary. Also insisted that on the few that were used that the holes be filled in. The foreman said he'd never heard of anything like that!!! I've learned from the home inspectors as I attend all of my home inspections for properties in which I am involved as either the selling or listing agent.

If they used 3 tab shingles and they were not aligned properly, can we ever expect them to be any better than what we're seeing right now? It sounds like they might not have nipped off the corners and maybe didn't have consistent headlap. With one, you'll see the corners jutting up and with the other you'll see an uneven ridgeline.

That's why the accessory shingles are marked so one can't screw up the alignment. They might look better when the sun heats them up if they activate and adhere but I guess my question is whether they'll adhere. It's still too early here to expect them to activate properly, even on a sunny day.